A Flutter console app for MeshCoreNG repeaters and companion radios. Connect over USB serial, BLE, or TCP, send CLI commands, and configure your mesh node. MeshCLI NG gives you a terminal-style console for MeshCoreNG devices in three modes: Mode What it connects to Transport Companion A companion radio running the MeshCore companion firmware BLE · USB · TCP Remote A remote repeater reached via the companion over the mesh (via companion) -r Serial A repeater connected directly over USB serial USB serial The app has no messaging UI and no node browser — it is a focused CLI console. In direct serial mode it also includes an interactive configuration panel that reads all settings from the device, lets you edit them, and sends only the changed values. Android USB / OTG For USB serial on Android the phone must support USB OTG / USB host. This is needed because the MeshCore node is plugged directly into the phone, so the phone has to act as the USB host and give the app permission to open the serial port. Use: a USB-C OTG adapter or USB-C data cable a MeshCore node/repeater that exposes a USB serial port Android's USB permission popup when the app scans/connects When a supported USB serial node is plugged in, Android should offer MeshCLI NG as an app for that USB device. If it does not, install the newest APK, unplug/replug the node, and check that the cable is a data/OTG cable. If OTG is not available, use BLE or TCP instead.